Air Particulars – Can you improve air quality while also managing energy use? An Energy Trust expert Q&A.

Air Particulars – Can you improve air quality while also managing energy use? An Energy Trust expert Q&A.


an industrial facility

Air quality and emissions have become a focal point for the State of Oregon, and Energy Trust has seen an increase in projects with related technologies such as the installation of additional air pollution control devices (APCDs). Here are some common questions that can be helpful in guiding your decisions related to air quality control. Reach out to your Program Delivery Contractor if you are considering a project related to air quality and emissions.

Josh Weissert, technical expert and Program Delivery Contractor at Energy Trust of Oregon, answers some frequently asked questions below.

Josh Weissert 1.) How can we limit energy consumption on these air pollution control systems? Whether you are retrofitting an existing system or adding an additional APCD, Energy Trust recommends considering a Variable Frequency Drive (VFD) on the motor to enable flexibility for tuning. With a direct drive arrangement and a VFD, wear components including belts, sheaves and bearings are eliminated, reducing maintenance costs and improving reliability.

We recommend controlling the VFD to a suction static pressure on the dirty side of the APCD to accomplish a constant flow control method. Excess runtime can be a significant source of unnecessary energy consumption. For more energy savings consider breaking the duct runs into zones fed directly into the APCD, installing dampers and only ventilating when needed.

2.) What conveyance velocity do you recommend in dust collection systems? The American Conference of Governmental Industrial Hygienists has established best practices in The Industrial Ventilation: A Manual of Recommended Practice for Design. Typical values range from 3,500 fpm to 6,000 fpm depending on the material. Setting conveyance velocity higher than necessary wastes energy and wears out pipes more quickly.

3.) If my filters are fouled do I consume excess energy on my fan? It depends. If the fan has a VFD or damper and is controlled to maintain a constant flow, then yes, fouled filters can increase fan energy consumption. If the fan is constant speed with no other volumetric controls, then fan energy is typically lower with high pressure and lower flow. Actual impacts depend on the intersection of the fan and system curves.

4.) Is it more efficient to keep motors running during breaks or to stop and then restart them? A motor that is off will always use less energy than one that is in a starting sequence. Starting up a machine does require a spike of current that’s as much as 10 times the running rate, but that spike lasts for just a few seconds or minutes – and over time this is much less energy than used to keep it running when it’s not in use. There are limits to how frequently a motor is designed to start up, so we recommend talking with your motor vendor if your facilities is restarting equipment more frequently than 2 times per hour.

Click here to learn how Energy Trust can help with your next energy-efficiency upgrade. »